Cisco 600W Uživatelský manuál Strana 1

Quick Start GuideCisco 600W Redundant Power SystemQuick Start Guide with License and Warranty Information1 Cisco 90-Day Limited Hardware Warranty Term

10Figure 8 Redundant-with-Reboot ConfigurationFigure 9 Mixed ConfigurationCable Connection ProceduresBefore connecting to external devices, read the p

11WarningAttach only the Cisco RPS (model PWR600-AC-RPS) to the RPS receptacle. To see translations of the warnings that appear in this publication, r

12Figure 11 RPS Connector Location on a Cisco Switch (Typical)Figure 12 RPS 8-Pin Connector Location on a Cisco Router or Concentrator (Typical)Figure

13Step 3 Connect the DC-input end of the cable to a Cisco RPS rear-panel connector as shown in Figure 14 or Figure 15.Figure 14 Connecting a One-to-On

145 Power Up the EquipmentStep 1 If you are using the redundant-with-reboot configuration (not recommended), power up the switch by connecting the AC

15Documentation CD-ROMCisco documentation and additional literature are available in a Cisco Documentation CD-ROM package, which may have shipped with

16• Resolve technical issues with online support• Download and test software packages• Order Cisco learning materials and merchandise• Register for on

178 Obtaining Additional Publications and InformationInformation about Cisco products, technologies, and network solutions is available from various

18

19

21 Cisco 90-Day Limited Hardware Warranty TermsThere are special terms applicable to your hardware warranty and various services that you can use dur

Corporate HeadquartersCisco Systems, Inc.170 West Tasman DriveSan Jose, CA 95134-1706USAwww.cisco.comTel: 408 526-4000800 553-NETS (6387)Fax: 408 526-

3To Receive a Return Materials Authorization (RMA) NumberContact the company from whom you purchased the product. If you purchased the product directl

4Related Hardware InstallationAdditional hardware installation documents provide information about installing interconnection adapters in routers and

53 Install the ChassisSafety InformationFor safety information you need to know before working on your Cisco RPS, see the Regulatory Compliance and S

6Figure 2 Brackets for Telco Rack-MountingAttaching BracketsAttach the mounting brackets to the chassis as shown in Figure 3, Figure 4, or Figure 5, u

7Figure 5 Bracket Attachment for Telco Rack with Rear Panel ForwardInstalling the Chassis in a RackInstall the chassis in the rack. Rack-mounting scre

8Connection Methods and CablesTable 2 summarizes the redundancy options and cable requirements for the various external devices that can be supported

9• Fully redundant—Figure 7. The power source is fully redundant because there are two AC input modules and two DC output power modules connected to e