Cisco UCS E-Series Instalační příručka stáhnout pdf (Strana 28)

Hardware Installation Guide for Cisco UCS E-Series Servers

Installing E-Series Servers in Cisco ISR G2 Routers

Cisco UCS E-Series Server Modules Hardware Installation Guide

OL-26447-01

Installing and Replacing the PCIe Assembly on the Double-Wide E-Series

Servers

PCIe Assembly

Figure 15 shows the PCIe Assembly, which consists of a PCIe card, a flex assembly which connects the

PCIe slot to the motherboard, and a plastic bracket which slides over the end of the PCIe card.

Figure 15 PCIe Assembly

Removing the PCIe Assembly

Follow these steps to remove the PCIe Assembly:

Step 1 Connect the wrist strap clip to an unpainted portion of the chassis frame to channel unwanted ESD

voltages to ground.

Step 2 Turn off power to the router.

The Cisco 3900 series routers support OIR. (See the “Online Insertion and Removal on a Cisco ISR G2

Router” section on page 22).

Step 3 Using either a number 1 Phillips screwdriver or a small flat-blade screwdriver, unscrew the captive

screws on the faceplate. Loosen the cover faceplate and remove it. See Figure 16. Save the screws.

1 Plastic Bracket 2 Flex Assembly

3 PCIe Card

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35 36

Žádné komentáře

Cisco UCS E-Series Instalační příručka Strana 28