Cisco RSP2 - Route Switch Processor 2 Specifikace stáhnout pdf (Strana 41)

OL-4923-01 B0

Installation Procedures

See the following sections for the configuration tasks required to run the RPR/RPR+, SSO with NSF,

FSU, and SLCR features.

• Enabling the Router, page 41 (required)

• Copying an Image onto an RSP, page 42 (required)

• Setting the Config-Register Boot Variable, page 43 (optional)

• Configuring RPR and RPR+, page 43 (optional)

• Configuring SLCR, page 59 (optional)

• Configuring NonStop Forwarding (NSF), page 49 (optional; but SSO required)

• Performing a Fast Software Upgrade, page 56 (optional)

• RPR, RPR+, SSO, and FSU Troubleshooting Tips, page 58 (optional)

• Configuring SLCR, page 59 (optional)

Enabling the Router

Step 1 At the user-level EXEC prompt, enter the enable command. The EXEC prompts you for a

privileged-level password as follows:

Router> enable

Password:

Step 2 Enter the password (the password is case sensitive). For security purposes, the password is not displayed.

When you enter the correct password, the system displays the privileged-level system prompt (#):

Router#

The completes the enabling the router procedure.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 87 88

Žádné komentáře

Cisco RSP2 - Route Switch Processor 2 Specifikace Strana 41