
543
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(32)S9
Conditions: This symptom is observed on a Cisco Catalyst 6500 series switch and Cisco 7600 series
router that have a PA-MC-E3 port adapter when you configure 16 or 128 channel groups on each
time slot (that is, time slots 1-31) and then generate traffic just above line rate traffic through all the
channel groups. Note that the symptom is not platform-specific.
Workaround: Stop the traffic and reset the E3 controller of the PA-MC-E3 port
adapter.
• CSCsj39711
Symptoms: Configuration of “hw-module slot x tcam compile acl no-merge” is missing after OIR
of E3 POS card.
Conditions: OIR of POS E3 line card.
Workaround: Enter the command again.
• CSCsj47271
Symptoms: The following error message appears while removing an MFR bundle interface:
%FIB-2-IF_NUMBER_ILLEGAL: Attempt to create CEF interface for MFR1 with illegal
if_number: 0
Conditions: The error occurs if the MFR bundle interface is removed without removing the member
links from the bundle.
Workaround: Remove the MFR bundle, wait approximately 1 minute, then re-add the configuration
for the affected MFR bundle.
• CSCsj47347
Symptoms: Using CLI to delete a child policy on a Cisco 7500 series router causes the VIP to crash.
Conditions: The router has a hierarchical QoS policy attached to an interface. Traffic is flowing
through the QoS policy. There are BGP updates happening on the router. The no policy- map
command is executed to delete the child policy. The router is running Cisco IOS Release 12.0(32)S6.
Workaround: There is no workaround.
• CSCsj50513
Symptoms: All LCs goes to WAITRTRY state
Conditions: SFC is shut and one LC through which traffic is coming is shut.
Workaround: Reload the router.
• CSCsj52025
Symptoms: On enabling/disabling mcast hw-acceleration, the following error occurs:
1d06h: %REDUNDANCY-3-CONFIG_SYNC: Active and Standby lbl configuration out of sync"
message may be thrown.
Conditions: rpr-plus, enabling/disabling mcast hw-acceleration.
Workaround: There is no workaround.
• CSCsj52280
Symptoms: Using the pos ais-shut configuration may be lost on E3 POS linecard
Conditions: Occurs when following OIR or shutdown of card.
Workaround: There is no workaround.
Komentáře k této Příručce