Cisco OL-4015-08 Průvodce řešením problémů stáhnout pdf (Strana 120)

3-26

Cisco Broadband Local Integrated Services Solution Troubleshooting Guide

OL-5169-01

Chapter 3 Trouble Isolation Procedures

Component States

Trunk Termination Status—Optional Tokens

The following optional tokens can be used with the status trunk-termination command. They expand the

range of useful information returned. Either all, or none of the tokens can be used, with the exception of

the off-normal token, which must be used by itself (without any other tokens).

• Administrative State (admin-state). Valid values are:

–

UEQP—Unequipped; resource is not commissioned. Resource is not registered.

–

OOS—Termination was manually controlled out of service.

–

INS—Termination was manually controlled in service, but operationally may be available or

unavailable.

–

OOS-PENDING—Termination was manually controlled out of service with the graceful mode,

termination is still involved in a call.

–

MAINT—Termination was in maintenance mode, can run diagnostic commands.

–

MAINT-PENDING—Termination was manually controlled to the MAINT state, but

termination is still involved in call.

–

ALL—Return all possible states.

The following command example returns only those trunk terminations that are in administrative

state OOS (if any), and operating state IDLE (if any):

CLI> status trunk-termination tgn-id=12; cic=1-1000; admin-state=OOS;

oper-state=idle

• Operating State (oper-state). Valid values for the oper-state token are:

–

FA—Includes FAULTY, UNREACH, TEMP-DOWN, and DOWN.

–

FAULTY—The MGCP endpoint returned a permanent error code.

–

UNREACH—The MGCP endpoint was declared as not reachable. This indicates gateway

connectivity problems.

–

TEMP-DOWN—The MGCP endpoint is temporarily down.

–

DOWN—MGCP endpoint is down because GW termination has sent an RSIP-down message.

–

NF—Includes INT-MAINT, IDLE, BUSY, and ACTIVE.

–

INT-MAINT—Internal error recovery is in progress.

–

IDLE—Termination is not involved in a call, but is available.

–

BUSY— Termination is involved in transient call.

–

ACTIVE—Termination is involved in stable call.

–

UEQP—Termination is not equipped.

–

ALL—Returns all possible operational states.

The following command example returns only those trunk terminations that are FA (if any):

CLI> status trunk-termination tgn-id=12; cic=ALL; oper-state=FA;

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 369 370

Komentáře k této Příručce

Žádné komentáře

Cisco OL-4015-08 Průvodce řešením problémů Strana 120

Komentáře k této Příručce

Související produkty a manuály pro Sítě Cisco OL-4015-08