Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Datový list stáhnout pdf (Strana 145)

642 -531

Leading the way in IT testing and certification tools, www.testking.com

- 145 -

Answer:

password:testking1636

sensor#

1.sensor# copy current-config ftp://[email protected]/testking5287/backup-cfg

password: password2

2. sensor# show user all

3. sensor# config terminal

sensor(config)#no username service (service is the username for service account)

4.sensor(config)# privilege user tessking operator

5. sensor(config)#service virtual-sensor-configuration virtualSensor

6. sensor(config-vsc)#reset-signatures service-http all

Reference for Reset Signatures

http://www.cisco.com/en/US/products/sw/secursw/ps2113/products_command_reference_cha

pter09186a00801471c9.html#256266

QUESTION NO: 2

You are a network security at TestKing Inc. TestKing is installing new Cisco IDS

Sensors. You have to configure the new Sensors to permit remote access from trusted

hosts exclusively. Perform this task on one of the Sensors using the command line

interface (CLI). Refer to the following information and network topology graphic to

permit access from the IDS MC management station only to the Sensor.

Due to this being a new installation, you must remove the default allowed network

address. Note: Verify your configuration setting prior to saving, and then save your

configuration when finished.

Cisco IDS Parameters Settings

Sensor operator username/password operator/testking1636

Sensor administrator username/password admin/testking1636

Sensor IP address: 10.10.10.200/24

Default allowed network address: 10.0.0.0/8

Click on the picture of the host connected to an IDS Sensor by a serial console cable.

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 167 168

Žádné komentáře

Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Datový list Strana 145