Cisco CX-FEIP-1TX= Installation and con?guration Manuál s instrukcemi stáhnout pdf (Strana 172)

100

101

162

3300 ICP Technician’s Handbook

Migrate an SX-2000 PBX

Only the MicroLight can be migrated using this procedure. To migrate an

SX-2000 Light Non-redundant system simply replace the control cabinet

with a 3300 controller. Similarly replace a 3200 ICP controller with a 3300

controller. You cannot migrate the SX-2000 Light redundant control

system to an equivalent 3300 ICP.

To upgrade SX-2000 MicroLIGHT hardware for 3300 ICP control:

1. Remove the Main Controller (MMC) from slot 1/1/1.

2. Install a triple FIM in that slot.

3. Remove any FIM carrier cards in the DSU slots.

4. Do NOT remove any other cards.

An SX-2000 MicroLIGHT system converted to 3300 control uses fiber

interface modules (FIM) of the triple FIM carrier card as required:

• One triple FIM carrier card

• One control resources card

• One peripheral switch control (PSC) Card

• One to eight peripheral interface cards (PIC)

• Optionally, one to four DSU cards 0 DSU1 through DSU4.

Any DSU or peripheral cabinets that were connected to the MicroLIGHT,

must now be connected by fiber directly to the 3300 ICP controller.

Tip: Refer to Knowledge Base Article 04-1000-00068 (TB 58005193) for

Migration procedure details.

Triple FIM Carrier Card Port When connected, support

Circuit 1 (bottom) PER cards

Circuit 2 DSU in slots 2 and 3

Circuit 3 (top) DSU in slots 4 and 5

1 2 ... 167 168 169 170 171 172 173 174 175 176 177 ... 403 404

Komentáře k této Příručce

Žádné komentáře

Cisco CX-FEIP-1TX= Installation and con?guration Manuál s instrukcemi Strana 172

Komentáře k této Příručce

Související produkty a manuály pro Sítě Cisco CX-FEIP-1TX= Installation and con?guration