Cisco Catalyst 8510 MSR Uživatelský manuál stáhnout pdf (Strana 11)

Release Notes for Cisco IOS Release 12.0(10)W5(18b) Feature Packs for the Cisco Catalyst 8510 MSR and LightStream 1010 ATM Switch

78-10701-02

Installation Notes

Select a root directory where the Cisco IOS files reside (for example, d:\cpswinst\images).

Caution Make sure you set up your local PC as a TFTP server. If you do not, you cannot perform

the copy procedure. This caution applies to both TFTP and rcp.

Step 4 Establish a console session from your local PC (which is now configured as a TFTP server) to the

Catalyst 8510 MSR and LightStream 1010 by using one of these methods:

• Connect the PC com port to the Catalyst 8510 MSR and LightStream 1010 console port.

This is the recommended method. When you reload the Catalyst 8510 MSR and LightStream 1010

with the new image in Step 13, you remain connected to the Catalyst 8510 MSR and

LightStream 1010.

• Establish a Telnet session from the PC to the Catalyst 8510 MSR and LightStream 1010. If you

choose to use Telnet, your connection to the Catalyst 8510 MSR and LightStream 1010 will be lost

when it is reloaded.

Caution Make sure that your PC is set up to communicate with the connected device through its

network port.

Step 5 Connect your PC’s LAN port to the corresponding LAN port on the Catalyst 8510 MSR and

LightStream 1010. If you are making a direct connection to the Catalyst 8510 MSR and

LightStream 1010 via Ethernet or Fast Ethernet, use an Ethernet crossover cable. If connecting to the

Catalyst 8510 MSR and LightStream 1010 via an Ethernet or Fast Ethernet hub or Token Ring MAU

(hub), use straight-through cable.

Note We recommend that you back up the Catalyst 8510 MSR and LightStream 1010

configuration before upgrading the Catalyst 8510 MSR and LightStream 1010

software.

Step 6 At the prompt, enter your password:

Password: <password>

Step 7 At the prompt, enter enable; then enter your password:

Router# enable

Password: <password>

Step 8 At the prompt, enter the following command to copy the new software image from the PC CD-ROM

drive to the Catalyst 8510 MSR and LightStream 1010:

Router# copy tftp flash

In the next series of steps, you download the Cisco IOS Release 12.0(10)W5(18b) images that you want

installed on your Catalyst 8510 MSR and LightStream 1010.

Step 9 At the prompt, enter the IP address of your PC, as shown in the following example:

Address or name of remote host [255.255.255.255]? 131.108.1.1

This is the IP address of your local PC, not that of the Catalyst 8510 MSR and LightStream 1010.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Žádné komentáře

Cisco Catalyst 8510 MSR Uživatelský manuál Strana 11