Cisco WAP54GX Uživatelská příručka stáhnout pdf (Strana 22)

Chapter 5: Setting up the Wireless-G Access Point

Using the Setup Wizard

Wireless-G Access Point

2. Press the Access Point’s orange Cisco logo on its front panel. When the logo turns white and begins to flash,

press the SecureEasySetup button on another device. The Access Point’s Cisco logo will stop flashing when

the device has been added to the network. Then repeat this procedure for each additional SecureEasySetup

device.

When you have finished configuring the devices in your wireless network, click the Next button to continue.

3. The Setup Wizard will ask you to review your settings before it saves them.

Click the Yes button if you are satisfied with your settings, or click the No button if you do not want to save

your new settings.

Figure 5-14: Configure Wireless Settings Screen

Figure 5-15: Confirm New Settings Screen

NOTE: You can only add one SecureEasySetup device at a time.

NOTE: Write down these settings. You may need to manually configure non-SecureEasySetup

devices in the future.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 83 84

Žádné komentáře

Cisco WAP54GX Uživatelská příručka Strana 22