Cisco 2520-RF - 2520 Router Specifikace stáhnout pdf (Strana 92)

B-10 Cisco Multiport Router Installation and Configuration Guide

Closing the Chassis

Step 9 Insert the new SIMM by sliding the end with the metal ﬁngers into the

appropriate SIMM connector socket (labeled CODE0 or CODE1) at

approximately a 45-degree angle to the system card. Gently rock the SIMM back

into place until the latches on both sides snap into place. Do not use excessive

force because the connector may break.

Step 10 Replace the router cover following the procedure in the next section, “Closing

the Chassis.”

Closing the Chassis

This section describes the procedure for closing the chassis by replacing the cover.

Tools Required

You will need the following tools to replace the cover:

• Medium-size ﬂat-blade screwdriver (1/4 inch [0.625 cm])

• Size M 3.5 hex-head nut driver (optional)

Replacing the Cover

Take the following steps to replace the cover:

Step 1 Position the two chassis sections, as shown in Figure B-5.

Step 2 Referring to Figure B-5, press the two chassis sections together and ensure the

following:

• The top section ﬁts into the rear of the bottom section. (See A in Figure B-5.)

• The bottom section ﬁts into the front of the top section. (See B in

Figure B-5.)

• Each side of the top and bottom sections ﬁts together. (See C in Figure B-5.)

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 115 116

Žádné komentáře

Modely	Typ Dokumentu
KFC-W3010	Uživatelský manuál Kenwood KFC-W3010 User Manual [es] , 2 stránky
KFC-XW1224D	Uživatelský manuál Инструкция по эксплуатации Kenwood KFC-XW1224D, 2 stránky
KFC-S502P	Uživatelský manuál Инструкция по эксплуатации Kenwood KFC-S502P, 2 stránky
KSC-8803	Uživatelský manuál Kenwood KSC-8803 User Manual, 2 stránky
KSC-9903	Uživatelský manuál Kenwood KSC-9903 User Manual, 2 stránky

Cisco 2520-RF - 2520 Router Specifikace Strana 92