17
Cisco Router and Security Device Manager Quick Start Guide
78-16254-06
I Use the Cisco IOS Startup Sequence
Step 1 Connect the light blue console cable, included with your router, from the blue console port on your router
to a serial port on your PC. Refer to your router’s hardware installation guide for instructions.
Step 2 Connect the power supply to your router, plug the power supply into a power outlet, and turn on your
router. Refer to your router’s quick start guide for instructions.
Step 3 Use HyperTerminal or a similar terminal emulation program on your PC, with the terminal emulation
settings of 9600 baud, 8 data bits, no parity, 1 stop bit, and no flow control, to connect to your router.
Step 4 At the prompt, enter the enable command. The default configuration file does not configure an enable
password.
yourname> enable
yourname#
Step 5 Enter the erase startup-config command.
yourname# erase startup-config
Step 6 Confirm the command by pressing Enter.
Step 7 Enter the reload command.
yourname# reload
Step 8 Confirm the command by pressing Enter.
After you press Enter, the router will begin executing the standard startup sequence. If you want to use
SDM to perform subsequent configurations for the router, you must manually configure the router to
support web-based applications, and the Telnet and Secure Shell (SSH) protocols. You must also create
a user account with a privilege level of 15. See the “I Want to Enable SDM on a Router I Configured
Using the Cisco IOS Startup Sequence” section for this information.
I Want to Enable SDM on a Router I Configured Using the Cisco IOS Startup
Sequence
This section provides information on enabling SDM on a router that has been configured using the Cisco
IOS startup sequence or the CLI. If you erased the factory startup configuration in order to use the Cisco
IOS startup sequence, you can still use SDM. In order to do so, you must configure the router to support
web-based applications, configure it with a user account defined with privilege level 15, and then
configure it to support the Telnet and SSH protocols. These changes can be made using a telnet session
or using a console connection.
Configuring the Router to Support Web-Based Applications, a User with Priv 15, and Telnet/SSH
Step 1 Enable the router’s HTTP/HTTPS server, using the following Cisco IOS commands:
Router(config)# ip http server
Router(config)# ip http secure-server
Router(config)# ip http authentication local
If the router uses an IPSec Cisco IOS image, the HTTPS server is enabled. Otherwise only the HTTP
server is enabled.
(16 stránky)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce