Cisco 1600R Instalační příručka stáhnout pdf (Strana 77)

Hardware Specifications and Cable Pinouts C-5

Cable Pinouts

Table C-4 Console Cable and Adapter Pinouts

You can identify a rollover cable by comparing the two modular ends of the cable. (See

Figure C-1.) Holding the cables in your hand, side-by-side, with the tab at the back, the

wire connected to the pin on the outside of the left connector (pin 1) should be the same

color as the pin on the outside of the right connector (pin 8). On Cisco cables, pin 1 is white

on one connector, and pin 8 is white on the other connector.

Figure C-1 Identifying a Rollover Cable

Console

Port (DTE)

RJ-45-to-RJ-45

Roll-Over Cable

Signal RJ-45 Pin RJ-45 Pin DB-9 Pin DB-25 Pin Signal

–1 8 7 4 –

DTR 2 7 4 20 DSR

TxD 3 6 3 2 RxD

GND 4 5 5 7 GND

GND 5 4 5 7 GND

RxD 6 3 2 3 TxD

DSR 7 2 6 6 DTR

–8 1 8 5 –

Pin 1

H10632

Pin 8

Pin 1 on one connector and

pin 8 on the other connector

should be the same color.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 87 88

Žádné komentáře

Cisco 1600R Instalační příručka Strana 77