Cisco 10720 - Internet Router Specifikace stáhnout pdf (Strana 52)

3-20

Book Title

78-13113-06 B0

Chapter 3 Installing and Removing the Uplink Cards

Turning On Power to the Router

Figure 3-27 Power Switch in the Off Position

Step 3

Verify that the power switch located on the front of the power supply is in the off (O) position. (See

Figure 3-27.)

Figure 3-28 Tightening the DC Lead Receptacle

Step 4

Insert the stripped end of the ground lead all the way into the ground lead receptacle on the DC-input

power supply and tighten the receptacle screw using a 1/8-inch flat-blade screwdriver. (See Figure 3-28.)

Note Make sure the entire stripped end of each lead is inserted all the way into its receptacle. If any

exposed wire at the stripped end of a lead is visible after inserting the lead into its receptacle, remove

the lead from the receptacle. Use a wire cutter to cut the stripped end of the lead to fit the receptacle.

IN OK

OTF

IN OK

OTF

57872

1 Ground lead

122053

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 82 83

Žádné komentáře

Cisco 10720 - Internet Router Specifikace Strana 52