Cisco 1005 - 1005 Router Uživatelský manuál Strana 5

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 10
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 4
115200 Cisco 1005, 1600, and 2509
through 2512 AUX on Cisco 2600
and 3600 Modules and WICs that
support external asynchronous
modems (for example, NM-16A,
WIC-2A/S)
Note: If you are routing over the AUX port, notice that each character generates a processor interrupt.
Abnormally high CPU utilization may be resolved by using a lower AUX port speed.
Modem Configuration
We recommend using the modem autoconfigure type <modemcap_name> command (introduced in Cisco
IOS Software Release 11.1), to configure modems attached to async lines. If you are using a version of
Cisco IOS Software earlier than 11.1, script startup and script reset can be used to configure the modems
via a chat script.
For most applications, a modern modem should be configured as follows:
Reset to factory defaults (use a hardware flow control template if possible).
Use hardware (RTS/CTS) flow control.
Use normal modem control (hang up on DTR drop; drop DCD on carrier drop).
Enable, but do not require, error control (LAP-M [V.42] and MNP).
Enable, but do not require, data compression (V.42bis).
Enable all modulations supported by the modem.
Lock DTE speed at the highest rate supported by both the modem and the async line.
Enable autoanswer if needed; when in autoanswer mode, ignore the escape sequence (+++).
For details on the command set used by your modem, consult the documentation provided by your vendor
or see the www.56k.com page for a list of links to this documentation.
Using Modemcaps and modem autoconfigure
Cisco IOS Software maintains a set of built-in modemcaps for various internal and external modems. Here's
an example modemcap from Cisco IOS Software Release 11.3(9)T:
router#show modemcap
default
codex_3260
usr_courier
usr_sportster
hayes_optima
global_village
viva
telebit_t3000
microcom_hdms
microcom_server
nec_v34
nec_v110
Zobrazit stránku 4
1 2 3 4 5 6 7 8 9 10

Komentáře k této Příručce

Žádné komentáře