Cisco 194424 - Interface Module ISDN-BRI Uživatelský manuál Strana 16

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 28
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 15
isdn switch-type
MOD-16
Release 12.0(4) T
Note If you are using the Multiple ISDN Switch Types feature to apply ISDN switch types to
different interfaces, refer to the “Setting Up ISDN Basic Rate Service” chapter in the Dial Solutions
Configuration Guide for additional details.
Note Cisco IOS Release 11.3 T introduced ISDN switch type changes. The command parser will
still accept the following switch types: basic-nwnet3, vn2, and basic-net3; however, when viewing
the NVRAM configuration, the basic-net3 or vn3 switch types are displayed, respectively.
If different Cisco MC3810 BRI ports interface with different ISDN switch types, you can use global
and interface commands in any combination, as long as you remember that interface commands
always override a global command. For example, if you have a BRI QSIG switch interface on BRI
voice ports 1, 2, 3 and 4, but a BRI 5ess switch interface on BRI backup port 0, you can configure
the ISDN switch types in any of the following combinations:
Enter isdn switch-type basic-qsig in global configuration mode, and enter
isdn switch-type bri-5ess on interface 0.
Enter isdn switch-type bri-5ess in global configuration mode, and enter
isdn switch-type basic-qsig on interfaces 1, 2, 3 and 4 individually.
Enter isdn switch-type bri-5ess on interface 0, and enter isdn switch-type basic-qsig on
interfaces 1, 2, 3 and 4 individually.
If you enter the no isdn switch-type command in global configuration mode, any switch type that
was originally entered in global configuration mode is cancelled; however, any switch type
originally entered on an interface is not affected. If you enter the no isdn switch-type command in
interface configuration mode, any switch type configuration on the interface is cancelled.
Note The voice-port codec command must be configured before any calls can be placed over the
connection to the PINX. The default codec type is G729a.
Zobrazit stránku 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Komentáře k této Příručce

Žádné komentáře