Cisco 3545 MCU Uživatelský manuál stáhnout pdf (Strana 18)

2-12

Installation and Upgrade Guide for Cisco Unified Videoconferencing 3545 MCU Releases 5.6 adn 5.7

OL-17013-01

Chapter 2 Installing the Cisco Unified Videoconferencing 3545 MCU

Physical Description

Physical Description of the Cisco Unified Videoconferencing 3545 MCU

Module

The Cisco Unified Videoconferencing 3545 MCU module has a 10/100BaseT Ethernet port on the front

panel that uses an RJ-45 connector to connect to the network. There is an asynchronous, 9-pin serial port

that you can use with a hyperterminal program to configure and monitor the module.

Figure 2-1 shows the front panel of the Cisco Unified Videoconferencing 3545 MCU module. Table 2-1

describes the components of the front panel.

Figure 2-1 Cisco Unified Videoconferencing 3545 MCU Front Panel

Physical Description of the Cisco Unified Videoconferencing 3545 EMP

Module

Figure 2-2 shows the front panel of the Cisco Unified Videoconferencing 3545 EMP board. Table 2-1

describes the components of the front panel.

Figure 2-2 Cisco Unified Videoconferencing 3545 EMP Front Panel

157270

10/100Base T-1

SERIAL

RST

ACTALARM

CPU-HightGK Reg

SWAP

RDY

Ta b l e 2-1 Front Panel Components

Component Description

10/100 BaseT-1 connector An RJ-45 connector that provides the primary Ethernet connection

for the IP network port.

SERIAL connector A DB-9 connector that allows you to connect a PC terminal for local

configuration.

RST button Allows you to reset the board manually.

GK Reg LED (on the

Cisco

Unified

Videoconferencing

3545 MCU)

MC LED (on the Cisco Unified

Videoconferencing

3545 EMP)

Lights green when the Cisco Unified

Videoconferencing

3545 MCU is registered with a gatekeeper, or

when there is no gatekeeper registered and the auto attendant feature

is enabled.

Lights green when the EMP is registered with the MCU.

CPU High LED Lights green when more than 50% of the MCU/EMP resources are

in use.

ACT LED Lights green to indicate that there is at least one currently active

conference on the MCU/EMP.

ALARM LED Lights green to indicate that an error has occurred and the

MCU/EMP requires resetting.

157271

10/100Base T

SERIAL

RST

ACTALARM

CPU-HightMC

SWAP

RDY

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 55 56

Komentáře k této Příručce

Žádné komentáře

Cisco 3545 MCU Uživatelský manuál Strana 18

Komentáře k této Příručce

Související produkty a manuály pro Hardware Cisco 3545 MCU