Cisco ASA5555-CU-2AC-K9 Instalační příručka Strana 69

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 76
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 68
4-19
Cisco ASA 5500-X Series Hardware Installation Guide
OL-32129-01
Chapter 4 Maintenance and Upgrade Procedures for the ASA 5500-X
Remove and Install the Power Supply
Figure 4-23 Color-coded Wires
Figure 4-24 shows the DC power supply with lead wires.
Figure 4-24 DC Power Supply with Lead Wires
Step 7
Insert the exposed end of one of the ground wires into the inlet on the DC power supply. After you push
in the wires, they are held in place with a spring, which makes the physical contact. Make sure that you
cannot see any wire lead. Only wires with insulation should extend from the DC power supply.
Step 8 Repeat Step 7 for the remaining two DC input power source wires: the positive lead wire and the negative
lead wire.
1 Negative (–) lead wire 2 Ground lead wire
3 Positive (+) lead wire
333057
1
2
3
333060
Zobrazit stránku 68
1 2 ... 64 65 66 67 68 69 70 71 72 73 74 75 76

Komentáře k této Příručce

Žádné komentáře