Cisco ATA adaptor Uživatelský manuál stáhnout pdf (Strana 10)

10 Cisco SPA100 Series Analog Telephone Adapters

Recommended hardware (not included): Two number-six pan-head

tapping screws, 5/8-in. length, with anchors for sheet rock installation.

WARNING Insecure mounting might damage the ATA or cause injury. Cisco

is not responsible for damages incurred by insecure wall-

mounting.

To mount the unit to the wall:

STEP 1 Determine where you want to mount the unit. Verify that the surface

is smooth, flat, dry, and sturdy.

STEP 2 Drill two pilot holes into the surface 58 mm apart (about 2.28 in.).

STEP 3 Insert a screw into each hole, leaving a gap of 5 mm (0.1968 in.)

between the underside of each screw head and the surface of the

wall.

STEP 4 Place the unit wall-mount slots over the screws and slide the unit

down until the screws fit snugly into the wall-mount slots.

5/8 in. (15.8 mm)

1 2 ... 5 6 7 8 9 10 11 12

Žádné komentáře

Cisco ATA adaptor Uživatelský manuál Strana 10